– 3 –
SPECIFICATIONS
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Physical:
6-7/
1
6"W x 4-
1
/4"H x
1
-
1
/4"D (
1
63mm x
1
08mm x 32mm)
Electrical:
12V Input Rating:
Input Voltage:
1
2VDC
Input Current: 50mA + Extension loop drain (
1
28mA max)
during normal operation. Increases to 400mA
when extension loop shorted.
Float Voltage:
1
3.65VDC
Standby Time: Exceeds 4 hrs with
1
.2AH or larger battery
Recharge Time: Up to 48 hours
Miscellaneous: PTC thermistor provides reverse battery
connection protection
Extension Polling Loop Rating:
Output Current:
1
28mA max. Do not draw more than
1
28mA on any individual extension loop
wire run.
Maximum line impedance:
20 ohms.
Miscellaneous: Refer to
Table 1,
for limits on polling loop
wire run length. The extension loop is power
limited.
SEE THE CONTROL PANEL'S INSTALLATION INSTRUCTIONS FOR
COMPLETE INFORMATION REGARDING THE LIMITATIONS OF
THE ENTIRE SECURITY SYSTEM.
Regulatory Agency Listings
UL 609
commercial burglary,
UL864
commercial fire,
UL985
household fire, and
UL1023
household burglary.
NFPA-72
Compliant
For the latest warranty information, please go to:
www.honeywell.com/security/hsc/resources/wa
FEDERAL COMMUNICATIONS COMMISSION STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation
Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the
equipment.
CLASS B DIGITAL DEVICE STATEMENT
This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the
following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict
accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been
type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in
Part
1
5 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated.
• Move the radio or television receiver away from the receiver/control.
• Move the antenna leads away from any wire runs to the receiver/control.
• Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch
circuits.
• Consult the dealer or an experienced radio/TV technician for help.
INDUSTRY CANADA CLASS B STATEMENT
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
FCC / IC STATEMENT
This device complies with Part
1
5 of the FCC Rules, and RSS2
1
0 of Industry Canada. Operation is subject to the
following two conditions: (
1
) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la partie
1
5 des règles de la FCC & de RSS 2
1
0 des Industries Canada. Son fonctionnement
est soumis aux conditions suivantes: (
1
) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit
accepter toute interférence reçue y compris les interférences causant une réception indésirable.