Honeywell 6808, Инструкция по установке и эксплуатации

Страница: 34 / 170

34
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Control Panel Installation

Flush Mounting Steps
1. Cut a hole in the sheet rock to the following dimensions: 8-¼” W x 6-5/8” H. If an electrical box is used, the box must be 1-3/8”
back from face of wall to accommodate the annunciator (see Figure 4.12).
2. Remove knockout holes as needed for wires.
3. Fit the annunciator back box into the hole and stabilize with mounting wires. Angle the mounting wires into the first hole past the
sheet rock. Secure the wires behind the screws as shown in Figure 4.13. When all four wires are in place, the back box should fit
snugly into the hole in the sheet rock.
4. After the annunciator wiring to the panel has been completed (described in Section 4.7), replace the electronic assembly in the back
box. Place the bezel over the back box and tighten the set screws on the bezel.
Figure 4.13 Flush Mounting the Back Box
Surface Mounting
The 5860 can be mounted directly to a surface or can be attached to a single, double, or four-square electrical box. The Model
5860TG/TR trim ring kit is available for use when surface mounting.
1. Drill holes in the surface to match the screw holes on the back box.
2. Fit the trim ring over the back box.
3. Attach the back box to the surface using screws provided.
4. After the annunciator wiring to the panel has been completed (described in Section 4.7), replace the electronic assembly in the back
box. Place the bezel over the back box and tighten the set screws on the bezel.
4.5.2 Model 5860 Connection to the Panel
Connect the 5860 to the panel as shown in Figure 4.14.
Figure 4.14 Model 5860 Connection to the Panel
Insert wires at an angle into the first holes past the sheet rock.
Secure the wires behind this screw.
Attach second set of wires to top of back box.
Supervised
Power Limited