Honeywell 4286, Настройка и устранение неисправностей, Страница: 3 / 11

Back to Top
- 3 -
Step-by-Step
Tech Support
Updated 7/27/10
Programming the Vista 10/15/20p:
1. There is no device programming on these panels. In order to program the panel to recognize the 4286 you
simply add the “Voice Module Access Code”
*28
Access Code for Phone Module [00]
ƒ
00 = disable
ƒ
1
st
digit: enter 1-9
ƒ
2
nd
digit: enter # + 11 for * or # + 12 for #
2. This option is only available for partition 1 on the Vista-20p panels.
ƒ
You can perform a Global arm/disarm by hitting your 4 digit code + 0 + command (1=off,
2=away, 3=stay).
ƒ
The user code must have access to both partitions for this command to work.
3. If remote access is desired we have to set up the panels Ring Detection Count.
*95
Ring Detection Count [0]
ƒ
00 = disable with this disable you can call the premise and after the answering machine picks
up you have 20 seconds to enter the 2 digit access code
ƒ
Enter 1-9 for Customers with out an answering machine or a dedicated line to the panel
ƒ
If they have an answering machine you can use the Answering Machine Defeat option by
Entering #15 here. This requires the customer to call, let ring once, hang up, and call back.
4. 10/15/20p Notes:
ƒ
4286 Phone Modules must have software version WA4286-15.1, V101, or higher (refer to the
label on the square 4286 microprocessor chip).
Programming the Vista-40/50 & 128b/bp/fb/fbp & 250bp/fbp:
1. We must enable the module in *93 Device Programming:
Device Prog?
1=Yes 0=No
0
Press 1 to enter into Device Programming
Device Address
01-30, 00=Quit
01
Since the 4286 Device Address can not be change enter address 04
04 Device Type
00
Enter 05 which is the “Voice (VIP) Module (4285/4286)” option
01 Console Par.
1
Enter the partition in which the 4286 will give you status upon first entering
Device Address
01-30, 00=Quit
00
Enter 00 to quit
Quit Menu Mode?
1=Yes 0=No
0
Enter 1 to exit the *93 menu mode
Figure 4: *93 Device Programming