7
Additional Features
Home and Office Security Safes
6
Emergency Override Key/
Battery Replacement
Your safe is equipped with an Emergency Override Key which
allows immediate access in case you forget your Passcode or the
batteries need replacing.
1. Locate and open the protective keypad cover on the front of
the safe.
2. Using a small Phillips head screwdriver, remove the 2 screws
securing the small Emergency Override Key lock cover
located just below the digital keypad. Pull forward on
the cover to remove and set aside with the small screws.
3. Insert the Emergency Override Key into the lock and turn
clockwise to the right.
4. Turn the handle upwards to the right to open the safe.
NOTE: If batteries need replacing, proceed with step 5.
Otherwise, proceed to steps 6-8.
5. Slide the battery compartment cover (located inside the
safe at the top of the door) forward and remove.
Remove and properly dispose of the (4) nonworking
batteries. Install 4 new “AA” batteries. Make sure
the batteries are installed in the proper direction as indicated
in the battery compartment. Slide the cover back into place.
6. Remove the Emergency Override Key, and before replacing
the lock cover, enter your personal Passcode to make sure
the safe will open.
7. Replace the lock cover using the 2 small screws and return
the Emergency Override Key to a secure place away from
the safe.
8. Close and lock the safe door.
Shelves
To allow for greater flexibility and further accommodate your particular storage
needs, this safe includes (1) Adjustable/Removable Shelf.
1. Position shelf so that the gripping ridges are on the top and towards the front
of the safe.
2. Locate the approximate position in the safe where you would like to place the
shelf and, using the guides molded into the walls of the safe, slide into place.
Low Battery Indicator
Every time the keypad is activated, the system automatically checks the power
level remaining in the batteries. If the power falls below a certain level, the red
light will flash every two seconds to indicate the need for new batteries. See
page 6 for instructions on replacing the batteries.
Disable / Enable Sound
1. To Enable (Turn on) the sound during normal operation, press the following
key sequence:
2. Repeat the process to turn the sound off.
+
-
+
-
