EN
14
EN0H-0474GE25 R1020
Installation
Install the device out of reach at a minimum installation
height of 200 cm.
The following tools are necessary for correct installa-
tion:
• Slot-head screwdriver for simple opening of the housing
cover
• Cross-head screwdriver or cordless screwdriver
• 5 mm stone drill bit for drilling the plug holes (5 mm) in
the wall
(1) Remove the front cover of the housing by:
• Inserting the screwdriver in the right-hand slot and
pushing downwards to lever the cover open
• Inserting the screwdriver in the left-hand slot and
pushing downwards to lever the cover open
(2) Remove the installation material
(4) Latch the 2 locking hooks of the front cover onto the locking webs of
the housing.
(5) Fold the front cover onto the housing.
(6) Latch in the cover audibly with a light pressure
(7) Seal the enclosed anti-tamper seal of
the gateway.
3
(3) Drill the four holes, each 170 mm apart
When drilling ensure you do not damage any utility pipes or cables
(electricity, water, IT network, etc) laid in the wall.
You should use at least 2, better 4 fixing points to fix the RNG5-STD
securely on the wall.
4
5
6
7
1
2
4
17
0
>
200
0
