BATTERY INSTALLATION/REPLACEMENT
1. Remove the transmitter's cover
(if it is not already
off) as described in
MOUNTING
Step 1.
2. Observe correct polarity and insert the battery
provided into the battery holder (see Fig. 2).
Take
care not to bend the antenna.
NOTE:
Replace battery
only
with:
Panasonic CR123A, Duracell DL123A,
ADEMCO 466 or HUIDERUI CR123A.
3. To replace the cover,
engage the hooks along one
edge and snap shut.
SPECIFICATIONS
Dimensions:
1-1/2"W x 3"H x 7/8"D
(38mm x 76mm x 22mm)
Battery:
3V Lithium (see
Note
in step 2 of
BATTERY
INSTALLATION
/
REPLACEMENT
)
BATTERY
CAUTION
:
Risk
of
fire,
explosion, and burns. Do not recharge, disas-
semble, heat above 212°F (100°C), or in-
cinerate. Dispose of used batteries promptly.
Keep away from children.
Note:
Constant exposure to high or low temperature or high humidity may reduce battery life.
TO THE INSTALLER
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to the user,
as well as acquainting the user with the proper operation and limitations of the alarm system and its component parts.
Recommendations must be included for a specific program of frequent testing (at least weekly) to insure the system's
operation at all times.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE
IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
FEDERAL COMMUNICATIONS COMMISSION STATEMENT:
The user shall not make any changes or modifications to the equipment unless authorized by the Installation
Instructions or User’s Manual.
Unauthorized changes or modifications could void the user’s authority to operate the equipment.
FCC / IC STATEMENT
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2), this device must accept any
interference received, including interference that may cause undesired operation.
Responsible Party / Issuer of Supplier’s Declaration of Conformity: Ademco Inc., a subsidiary of Resideo
Technologies, Inc., 2 Corporate Center Drive., Melville, NY 11747, Ph: 516-577-2000
The product should not be disposed of with other household waste. Check for the nearest authorized collection
centers or authorized recyclers. The correct disposal of end-of-life equipment will help prevent potential negative
consequences for the environment and human health.
Any attempt to reverse-engineer this device by decoding proprietary protocols, de-compiling firmware, or any similar
actions is strictly prohibited.
SUPPORT & WARRANTY INFORMATION
For the latest documentation and online support, please go to:
www.resideo.com
For the latest warranty information, please go to:
www.security.honeywellhome.com/warranty
The Honeywell Home Trademark is used under license from Honeywell International Inc.
This product manufactured by Resideo Technologies and its affiliates
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
2020 Resideo Technologies, Inc.
www.resideo.com
ÊK5503V2D0Š
K5503V2D 4/08 Rev. D
