Honda SB2040, Руководство оператора

Страница: 33 / 50

Snowblower Removing the Snowblower
7.
Remove the 3.5 x
80
mm spring clip from the lockout pin,
then engage the lockout pin into the push frame. You may
need to slightly raise or lower the blower head to get the
holes in the push frame and subframe to line up; reinstall
3
X
SPRING CLIP
the spring clip when the lockout pin is engaged.
LOCKOUT PIN
\
8.
Remove the
2.5
x 40 mm spring clip from
the J-hook end of the chute crank rod.
Remove the rod
from
the crank support.
Remove the J-hook from the worm gear,
then store the J-hook on the chute crank rod
with the spring clip.
crank support by removing the two
8 x 25 mm flange bolts from the support.
SPRING CLIP
Install the two bolts back into the frame.
9.
If desired, you may optionally remove the
Raise the height adjustment lever all the way
up; this will not be in the maximum position,
so
do not use excessive force.
the two x hex bolts, lock washers,
and hex nuts that hold the subframe to the
lawn tractor frame. Adjust the support on'the
blower head to relieve any binding on the
mounting bolts.
11.
Raise and support the blower head. Remove
112" LOCK WASHER
112" HEX
NUT
(2)
112 HEX BOLT
POP
52152
(9610)
31