Honda NX250 1989, Руководства

Страница: 62 / 108

HYDRAULIC BRAKE
a brake bleeder is not use the following procedure:
Pump up the system pressure with the brake lever until there
are no air bubbles in the fluid flowing out of the reservoir
hole.
Connect the bleed hose to the bleed valve and bleed the
system as follows:
Squeeze the brake lever, open the bleed valve 1 /4 turn and
close the valve.
NOTE
- Do release the brake lever until the bleed valve has been
closed.
2. Release the brake lever slowly and wail several seconds
aftrer it reaches the end of its travel.
Repeat steps 1 and 2 until air bubbles cease to appear in the
fluid coming out of the bleed valve.
Tighten the bleed valve.
TORQUE: 6 (0.6 4.3 ft-lb)
Fill the cylinder resevoir to the upper level mark with
DOT 4 brake fluid from a sealed container.
Install the diaphragm, plate and reservoir cover.
Tighten the reservoir cover screws.
TORQUE: 1.5 (0.15 kg 1.1 ft-lb)
BRAKE PAD/DISC
BRAKE PAD REPLACEMENT
NOTE
• Always replace the brake pads in pairs assure even disc
Push the caliper pistons all the way into caliper to gain clear-
ance for the new pads.
CAUTION
- Be careful the master cylinder does overflow when the
caliper pistons are compressed.
Brake fluid can cause damage to plastic or rubber sur-
face.
Remove the following:
— pad pin plug
— pad pin
- pads
PAD PIN PLUG AND—
PAD PIN
14-4