Honda HRS216SKA, Руководство пользователя

Страница: 13 / 24

13
Handlebar
1. Loosen the handlebar locking knobs.
2. Press and hold the blade control lever.
3. Swing the handlebar forward. Prevent the cable from getting
pinched or kinked.
When unfolding the handlebar, be sure to tighten the locking knobs
to secure the handlebar in the mowing position.
TROUBLESHOOTING
Engine Will Not Start
Loss of Power
Vibration
Mowing Problems
Possible Cause Correction
Blade control not engaged Hold blade control lever
against the handlebar
(
page 7 )
Fuel valve OFF Turn the fuel valve ON
(
page 3 ).
Out of fuel Refuel ( page 5 ).
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline Refuel with fresh gasoline
(
page 5 ).
Spark plug faulty, fouled, or
improperly gapped Gap or replace the spark plug
(
page 11 ).
Spark plug wet with fuel (flooded
engine) Dry and reinstall the spark
plug.
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take the mower to an
authorized Honda servicing
dealer for repair.
LOCKING
KNOB (2)
BLADE CONTROL LEVER
Possible Cause Correction
Grass is too tall Raise the cutting height
(
page 4 ), cut a narrower
swath, push at a slower
ground speed, or cut more
frequently.
Grass is too wet Allow the grass to dry
Mower deck is clogged Clean out the mower deck
(
page 12 ).
Air filter is clogged Clean or replace the air filter
(
page 10 ).
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline Refuel with fresh gasoline
(
page 5 ).
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take the mower to an
authorized Honda servicing
dealer for repair.
Possible Cause Correction
Grass and debris lodged under the
mower deck Clean out the mower deck
(
page 12 ).
Blade is loose Tighten loose blade bolts
(
page 9 ).
Blade is bent, damaged, or
unbalanced by improper
sharpening Take the mower to an
authorized Honda servicing
dealer for repair.
Mechanical damage, such as a
bent crankshaft
Possible Cause Correction
Mower is moving too fast for lawn
conditions Release the clutch lever and
push the mower slower.
Cutting height adjustment levers
set at different positions Set all levers at the same
cutting height position
(
page 4 ).
Mower deck is clogged Clean out the mower deck
(
page 12 ).
Grass is too wet Allow the grass to dry
Grass is too tall • Raise the cutting height
• Cut a narrower swath
• Use a slower ground speed
• Cut more frequently
Blade is dull, worn, or damaged Sharpen or replace the blade
if necessary (
page 9 ).
Wrong blade installed Install correct blade ( page 9 ).