Honda HRC216HXA, Руководство пользователя

Страница: 17 / 28

17
TROUBLESHOOTING
Engine Will Not Start
Loss of Power
Vibration
Mowing and Bagging Problems
Possible Cause Correction
Fuel valve OFF Turn the fuel valve ON
( page 3 ).
Out of fuel Refuel ( page 7 ).
Throttle lever in the wrong position Move the throttle lever to the
CHOKE position, unless the
engine is warm (
page 10 ).
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline
Refuel with fresh gasoline
( page 7 ).
Spark plug faulty, fouled, or
improperly gapped
Gap or replace the spark plug
( page 14 ).
Spark plug wet with fuel (flooded
engine)
Dry and reinstall the spark
plug.
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc.
Take the mower to an
authorized Honda servicing
dealer for repair.
Possible Cause Correction
Throttle not set to FAST Move the throttle lever to
FAST (
page 9 ).
Grass is too tall Raise the cutting height
( page 7 ), cut a narrower
swath, use a slower ground
speed, or cut more frequently.
Instead of mulching, try rear
discharging or bagging.
Mower deck is clogged Clean out the mower deck
( page 16 ).
Air filter is clogged Clean or replace the air filter
( page 13 ).
Bad fuel; mower stored without
treating gasoline, or refueled with
bad gasoline
Refuel with fresh gasoline
( page 7 ).
Fuel filter clogged, carburetor
malfunction, ignition malfunction,
valves stuck, etc.
Take the mower to an
authorized Honda servicing
dealer for repair.
Possible Cause Correction
Grass and debris lodged under the
mower deck
Clean out the mower deck
( page 16 ).
Blades loose Tighten loose blade bolts
( page 12 ).
Blades improperly mounted Upper blade must be aligned
with mounting bosses. (if the
upper blade is removed, an
accessory spacer plate must
be installed) ( page 12 ).
Blades bent, damaged, or
unbalanced by improper
sharpening
Take the mower to an
authorized Honda servicing
dealer for repair.
Mechanical damage, such as a
bent crankshaft
Engine speed too fast
Possible Cause Correction
Mower is moving too fast for lawn
conditions
Shift to a slower speed.
Throttle lever not in the FAST
position
Set throttle lever to FAST
Cutting height adjustment levers
set at different positions
Set all levers at the same
cutting height position
( page 7 ).
Grass bag clogged Wash the grass bag
( page 16 ).
Mower deck is clogged Clean out the mower deck
( page 16 ).
Blades dull, worn, or damaged Sharpen or replace the
blades if necessary
( page 12 ).
Wrong blades installed Install correct blades
( page 12 ).