Honda GX120T2, Инструкция к добавке

Страница: 27 / 30

15-2
dummyhead dummyhead
REDUCTION UNIT
REDUCTION UNIT
REDUCTION UNIT DISASSEMBLY/
ASSEMBLY
CHAIN (1/2) CAMSHAFT P.T.O. TYPE
(*) Refer to page of base shop manual (GX120UT2/
160UT2/200UT2, P/N 62Z4H00).
Drain the engine oil (page 3-3*).
INSPECTION: (page 15-3)
INSTALLATION:
Align the timing marks [1] on the crankshaft [2] and
camshaft [3] sprockets, install the drive chain [4]
onto the sprockets, and install them into the cylinder
barrel as a set.
VALVE LIFTER
(Pivot, pivot end and slipper surface)
PISTON Assy.
(Outer surface and big end bearing)
INSTALLATION:
Install the piston Assy. to the cylinder barrel with
the mark [1] on the piston head toward the push
rod hole [2] of the cylinder head.
(Cylinder inner surface)
CYLINDER BARREL
INSPECTION: (page 14-6
*
)
CONNECTING ROD LOWER
INSTALLATION:
Set the connecting rod lower with the oil dipper toward the camshaft.
(Big end bearing)
DOWEL PIN
CRANKSHAFT
INSPECTION: (page 14-6 * )
INSTALLATION:
Be careful not to damage the oil seal lips.
(Pin and gear teeth)
REMOVAL:
Mark the valve lifters so that the intake and
exhaust sides can be distinguished.
INSTALLATION:
Attach the valve lifters to the cylinder barrel
immediately before installing the camshaft.
CAMSHAFT
INSPECTION: (page 14-6
*
)
P.T.O. SHAFT
BEARING (6205)
CASE COVER
PACKING
DRIVE CHAIN
BOLT (8 x 32 mm) (6)
P.T.O. SHAFT
OIL SEAL
(Lips)
CRANKCASE COVER
INSTALLATION:
Be careful not to damage the oil seal lips.
OIL FILLER CAP PACKING
CHECK:
Replace if necessary.
OIL FILLER CAP
(With oil level gauge)
CRANKSHAFT
BEARING (6304)
(Lips)
OIL SEAL
CRANKSHAFT
BEARING (6205)
CONNECTING ROD BOLT (2)
(Threads and seating surface)
(6 x 34 mm)
10 N·m (1.0 kgf·m, 7 lbf·ft)
(7 x 34 mm)
12 N·m (1.2 kgf·m, 9 lbf·ft)
[1]
[2]
[1]
[2]
[3]
[4]
GX160:
GX200:
(Cam profile and journal)
62Z4H00X.book 2 ページ ２０１１年１２月９日 金曜日 午後５時４０分