Honda CRF450X, Руководство пользователя

Страница: 39 / 174

Before & After Competition Maintenance
Between Motos & Practice Maintenance
After practice or between motos you have a
chance to make additional checks and
adjustments.
• Clean accumulated dirt from under the
fenders and off the wheels, suspension
components, handgrips, controls, and
footpegs. A stiff, nylon parts cleaning brush
works well.
• Check tyre air pressure.
• Check spoke tension and rim lock security.
• Check sprocket bolts and nuts security.
• Clean the sides of the drive chain with a stiff,
nylon parts-cleaning brush. Lubricate and
adjust the chain as necessary.
Do not perform maintenance while engine is
running. Injury to your fingers or hands may
result.
• After adjustment, check that the chain adjuster
index marks (1) are in the same position on
each side. This will ensure that the rear wheel
is in proper alignment and allow maximum
performance from the rear disc brake.
Maintaining proper wheel alignment will also
extend brake pad wear.
(1) chain adjuster index marks
• Suspend the front wheel above the ground and
use the pressure release screws (2) to release
the built-up pressure (in excess of normal
atmospheric pressure: 0 kpa (0 kgf/cm
2 , 0
psi)) in the fork tubes. This pressure is caused
by normal fork action while riding. (If you
are riding at altitude, remember that fork
pressure of 0 at sea level will increase as
elevation increases.)
(2) pressure release screw
(1)
(2)
After Competition Maintenance
It is important to the long term performance of
your CRF to practice a consistent maintenance
program. Right after the event is a good time to
begin your next maintenance cycle.
After Race Lubrication
Apply a light coating of rust-inhibiting oil to the
drive sprocket and any steel portions of the
chassis or engine where the paint has worn away.
This will prevent rusting of the exposed metal.
Apply rust-inhibiting oil more heavily if the
event was particularly wet or muddy. Take care
to avoid spraying any oil near the brake pads or
the brake disc.
Remove the drive chain, clean and lubricate it
(page 97). Be sure the chain is wiped clean and
is dry before lubricating the chain.
Take care to prevent catching your fingers
between the chain and sprocket.
Servicing Your Honda
33
031-060.qxd 06.6.1 10:58 ページ33