Honda 2007 CRF250R, Руководство пользователя

Страница: 48 / 165

Servicing Your Honda
43
Air Cleaner
Refer to Safety Precautions on page 19.
The air cleaner uses polyurethane inner and outer
pieces which can’t be separated.
A dirty air cleaner will reduce engine power.
Proper air cleaner maintenance is very important
for off-road vehicles. A dirty, water-soaked,
worn-out, or defective air cleaner will allow dirt,
dust, mud, and other impurities to pass into the
engine.
Service the air cleaner more frequently if you
ride in unusually wet or dusty areas. Your Honda
dealer can help you determine the correct service
interval for your riding conditions.
Your CRF’s air cleaner has very specific
performance requirements. Use a new genuine
Honda air cleaner specified for your model or an
air cleaner of equal quality.
Proper air cleaner maintenance can prevent
premature engine wear or damage, expensive
repairs, low engine power, poor gas mileage, and
spark plug fouling.
Improper or lack of proper air cleaner
maintenance can cause poor performance and
premature engine wear.
NOTICE
Cleaning
1. Remove the seat (page 29).
2. Remove the air cleaner retaining bolt (1).
3. Align the two access top tabs (2) of the air
cleaner assembly (3) and “
∆
” mark (4) of the
air cleaner housing by rotating the air cleaner
assembly counterclockwise.
5. Remove the air cleaner element (5) from the
air cleaner holder (6).
(1) air cleaner retaining bolt
(2) two access top tabs
(3) air cleaner assembly
(4) “
∆
” mark
4. Remove the air cleaner keeping the two
access top tabs up.
(5) air cleaner element (8) hole
(6) air cleaner holder (9) air cleaner tab
(7) holder tab
6. Wash the air cleaner element in clean non-
flammable cleaning solvent. Then wash in
hot, soapy water, rinse well, and allow to dry
thoroughly.
The air cleaner element is made in two pieces:
inner and outer, which cannot be separated.
7. Clean the inside of the air cleaner housing.
8. Allow the air cleaner element to dry
thoroughly. After drying, soak the air cleaner
element in clean Pro Honda Foam Filter Oil
or an equivalent air cleaner oil.
Apply air cleaner oil to the entire surface,
inner and outer, and rub it with both hands to
saturate the air cleaner element with oil.
Squeeze out excess oil.
9. Apply a thin coat of Pro Honda White
Lithium Grease or equivalent to the sealing
surface between the air cleaner element and
air cleaner element holder.
(cont’d)
(4)
(1)
(3)
(2)
(8) (7)
(5)
(9)
(6)
10. Assemble the air cleaner element and holder.
Install the holder tab (7) of the holder in the
hole (8) of the air cleaner tab (9).
024-054.qxd 06.6.15 14:31 ページ43