Honda 20010 VT1300CX, Инструкции по установке

Страница: 14 / 18

2010 VT1300CX
13
ENGINE OIL
Before starting the engine, remove the anti-rust coating from the
engine and exhaust system using a mild detergent and water.
Rinse with clean water.
Hold the motorcycle in an upright position.
Remove the oil filler cap/dipstick and check the dipstick to make
sure the engine has oil.
Replace the oil filler cap/dipstick.
Start the engine and let it idle for 3 – 5 minutes.
Stop the engine and wait 2 – 3 minutes.
Remove the oil filler cap/dipstick and wipe it clean.
Insert the oil filler cap/dipstick without screwing it in, remove it and
check the oil level.
If the oil level is below or near the lower level line on the oil filler cap/
dipstick, and add the recommended engine oil to the UPPER level.
Reinstall the oil filler cap/dipstick.
When replacing the engine oil, refer to the Service Manual.
RECOMMENDED ENGINE OIL:
Pro Honda GN4 4-stroke oil or an equivalent motorcycle oil.
Viscosity: SAE 10W-30
API Classification: SG or higher.
JASO T 903 standard: MA
ENGINE COOLANT
• Using coolant with silicate inhibitors may cause premature wear
of water pump seals or blockage of radiator passages.
• Using tap water may cause engine damage.
• Do not spill coolant on painted or plastic surfaces as it may dam-
age the finish.
• The effectiveness of coolant decreases with the accumulation of
rust or if there is a change in the mixing proportion during usage.
For best performance change the coolant regularly as specified
in the maintenance schedule.
• Mix only distilled, low mineral water with coolant.
Hold the motorcycle in an upright position.
Check the reserve tank coolant level.
If the level is low, remove the coolant reserve tank cap, add coolant
to restore the level to the UPPER level mark.
When replacing the coolant, refer to the Service Manual.
OIL FILLER CAP/
DIPSTICK
UPPER
LOWER
RECOMMENDED ANTIFREEZE:
High quality ethylene glycol antifreeze con-
taining corrosion protection inhibitors
RECOMMENDED MIXTURE:
1:1 (mixture with distilled water)
UPPER LEVEL MARK
LOWER LEVEL MARK