© 2014 American Honda Motor Co., Inc - All Rights Reserved.
3 of 3
0SR73-HL5-100
KNOB
CLAMP
LARGE WASHER
LARGE WASHER
10. Align the left hinge arm to the lower left windscreen
bracket so that the holes in both components line up.
11. Insert a 6 x 30 mm bolt through the hole in the hinge
arm and pass it through the hole in the mounting
bracket.
12. Install a 6 mm lock-nut to the end of the bolt and
hand tighten the bolt. The hinge arm must rotate
freely on the bracket.
13. Insert a 1/4 inch lock-nut into the recessed area
on the inside of the female clamp. Hold the clamp
in place on the A-pillar, adjacent to the previously
installed hinge arm.
14. Slide the male clamp into place over the female
clamp as shown.
15. Insert a 6 x 20 mm bolt through the holes in the
clamps and install a 6 mm lock-nut as shown.
16. Place a large washer on the end of the knob and
pass it through the hinge arm.
17. Place a second large washer on the knob between
the hinge arm and the clamp.
18. Thread the knob stud into the nut in the clamp and
then hand tighten it, plus one full turn. Do not over-
tighten the stud.
19. Repeat Steps 13 through 18 for the clamp and hinge
arm on the right side of the windscreen.
MOUNTING BRACKET
6 mm LOCK- NUT
HINGE ARM
6 x 30 mm BOLT
6 x 20 mm
BOLT
1/4 inch LOCK-NUT (large)
MALE CLAMP
FEMALE CLAMP
6 mm LOCK-NUT
20. To adjust windscreen position, open the arms on the
cam locks and loosen the clamp screws. Slide the
windscreen up or down the A-pillars and retighten all
hardware once the desired position is achieved.
STUD
