© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
AII 37561-38377 (0711)
9 of 15
19. Using scissors cut one urethane tape in half, and
then cut one of the halves again. Wrap the cut pieces
around the beeper harness shown.
20. Install the connector clip to the beeper 2-pin
connector.
21. Using an isopropyl alcohol on a shop towel, clean
the vehicle panel where the beeper will attach.
22. Remove the adhesive backing from the beeper, and
attach it to the opening in the left rear speaker at the
location shown. Route the beeper harness through
the hole in the rear shelf.
720105BE
URETHANE
TAPE
BEEPER
BEEPER 2-PIN
CONNECTOR
BEEPER 2-PIN
CONNECTOR
CONNECTOR
CLIP
2-PIN CONNECTOR
(Wrap from the end of
the 2-pin connector.)
Wrap the urethane tapes
around the harness.
URETHANE
TAPE
(Cut in half.)
URETHANE TAPE
742405CE
BUZZER
HARNESS
ADHESIVE
BACKING
BUZZER
Attachment
position.
VEHICLE
PANEL HOLE
23. Secure the beeper harness to the vehicle harness
with one wire tie.
24. Plug the beeper 2-pin connector into the back-up
sensor harness 2-pin connector.
25. Wrap the remaining piece of a urethane tape around
the connector.
26. Secure the 2-pin connection to the vehicle harness
with one wire tie.
27. Route the back-up sensor harness as shown and
secure it to the vehicle harness with three wire ties.
742406CE
BEEPER
HARNESS
WIRE TIE
VEHICLE
HARNESS
742407CE
VEHICLE
HARNESS
BUZZER 2-PIN
CONNECTOR
BACK-UP SENSOR
HARNESS 2-PIN
CONNECTOR
WIRE TIE
TRUNK LID HINGE
2-PIN CONNECTOR
URETHANE TAPE
Cut in quarter
www.collegehillshonda.com
