© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
AII13220-10 (1911)
5 of 8
9.
Remove the four spring nuts from the rear bumper
lower cover. If the vehicle is equipped with the
standard hands-free access power tailgate, also
remove the two self-tapping screws and one clip as
shown.
REAR BUMPER
LOWER COVER
(Do not reuse.)
CLIP
(If equipped)
2 SELF-
TAPPING
SCREWS
(If equipped)
4 SPRING NUTS
If you are also installing the Hands-Free Access
Power Tailgate Kit, continue with step 10; otherwise,
go to step 14.
With accessory Hands-Free Access Power
Tailgate Kit
10. Release the two sensor bars on the accessory
hands-free access unit.
2 SENSOR BARS
4 RETAINING
TABS
ACCESSORY HANDS-FREE
ACCESS UNIT
11. While wearing eye protection, use an air saw to cut
off the accessory hands-free access unit along the
scribe line. Remove any burrs.
NOTE: Be careful not to cut the sensor bars. If
sensor bars are damaged, they must be replaced.
SCRIBE LINE
Cut off.
ACCESSORY
HANDS-FREE
ACCESS UNIT
AIR SAW
ACCESSORY
HANDS-FREE
ACCESS UNIT