2 of 6
AII 47348 (1209)
© 2012 American Honda Motor Co., Inc. – All Rights Reserved.
INSTALLATION
1.
Make sure you have the anti-theft code for the audio
and navigation system (if equipped).
2.
Disconnect the negative cable from the battery.
3.
Remove the dashboard left side cover (seven clips).
4.
Remove the driver’s dashboard lower cover (one
self-tapping screw, nine clips, unplug one vehicle
connector).
Customer Information:
The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
831901AB
DASHBOARD LEFT
SIDE COVER
7 CLIPS
7D2003BX
SELF-TAPPING
SCREW
VEHICLE
CONNECTOR
9 CLIPS
DRIVER’S
DASHBOARD
LOWER COVER
5.
Under the dashboard on the driver’s side of the
vehicle, install the control unit bracket to the vehicle
frame with one 6 x 16 mm flange bolt.
6.
On the right side of the steering shaft, locate the
vehicle 12-pin connector blue-taped and black-taped
to the vehicle harness, and remove the blue tape
and black tape to free the connector.
7.
Plug the vehicle 12-pin connector into the control
unit 12-pin connector.
831911BE
STEERING
SHAFT
VEHICLE 12-PIN
CONNECTOR
BLUE TAPE
Remove.
6 x 16 mm
FLANGE
BOLT
CONTROL
UNIT
VEHICLE
FRAME
CONTROL
UNIT
BRACKET
6 x 16 mm
FLANGE
BOLT
BLACK TAPE
Remove.
VEHICLE
FRAME
