20 of 24
AII 32445 (0605)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
FRONT
75. Position the 3-pin connectors in the cavity in the
headliner. Reinstall the rear interior light.
76. Using isopropyl alcohol on a shop towel, clean the
areas where the cushion tapes will attach. Using
scissors, cut three cushion tapes in half. Secure
DIN cable “A” to the headliner with six pieces of
cushion tape.
74. Using isopropyl alcohol on a shop towel, clean the
area where the cushion tape will attach. Using
scissors, cut one cushion tape in half. Secure the
interior light harness to the headliner with one half
cushion tape.
78. Secure the monitor bracket to the vehicle frame
with four 6 x 12 mm washer-screws.
Installing the Monitor Console
77. Using isopropyl alcohol on a shop towel, clean the
areas where the EPT sealers will attach. Using
scissors, cut three EPT sealers in half. Attach the
EPT sealer halves to the monitor bracket in the
areas shown. Cut the excess off the EPT sealers.
4916152H
FRONT
HEADLINER
OPENING
DIN
CABLE “A”
250 mm
CUSHION
TAPES (3)
Cut in half.
4916173H
MONITOR
BRACKET
EPT SEALERS (3)
Cut in half.
Cut off.
Cut off.
Cut off.
Cut off.
4916182H
FRONT
MONITOR
BRACKET
VEHICLE
FRAME
6 x 12 mm
WASHER-
SCREW
HEADLINER
OPENING
INTERIOR
LIGHT
OPENING
3-PIN
CONNECTOR
HEADLINER
OPENING
CUSHION TAPE
Cut in half.
INTERIOR
LIGHT
HARNESS
FOAM
BLOCK