5. CKP sensor 2 (PC2P) circuit short-circuit inspec-
tion
-1. Connect the ECM connector A.
-2. Check for continuity between the No. 4 (Gray/White)
and the body ground
.
◆
Is there continuity?
YES - Repair short circuit between the CKP sensor
and ECM.
NO -
Recheck with a new ECM.
DTC 8-2: Abnormal CKP 2 pulse
1. Reappearance test
-1. Connect the HDS (Dr. H or Pocket Tester) (page 5-
1) and clear the DTC (page 5-2).
• If the DTC cannot be cleared, continue trou-
bleshooting.
-2. Start the engine and let it idle with no load.
-3. Check the DTC with the HDS (Dr. H or Pocket
Tester).
◆
Does DTC 8-2 appear on the tester?
YES - Go to the step 2.
NO -
Temporary failure (Disappears).
2. CKP sensor 2 inspection
-1. Turn the ignition switch OFF and disconnect the
CKP sensor 2 4P connector.
-2. Measure the resistance between the No. 3 (Brown/
Red) and No. 4 (Gray/White) terminals of the CKP
sensor 2.
◆
Is there 970 ~ 1,170
Ω
?
YES - Recheck with a new ECM.
NO -
Replace the CKP sensor.
5-16
BF115A•BF130A
View from the terminal side
CKP SENSOR 4P CONNECTOR
(Wire harness side)
PC2P
（
GRAY/WHITE
）
View from the terminal side
CKP SENSOR 4P CONNECTOR
(Sensor side)
PC2P
（
GRAY/WHITE
）
PC2M
（
BROWN/RED
）
