10-2021
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
BATHROOM FAUCET WITH
WATERFLOW-ACTIVATED
LED LIGHT
MODELS
21-B42-WYBNHW-Z – Brushed nickel finish
21-B42-WYMBHW-Z – Matte black finish
21-B42WYHW-Z – Chrome finish
PACKAGE AND HARDWARE CONTENTS
PART
DESCRIPTION
QUANTITY
A
BB
AA
C
B
A
Faucet Body with
LED Aerator
1
B
Pop-up Drain Assembly
1
C
Non-lighted Aerator
1
AA
Rubber Washer
2
BB
Mounting Nut
2
Due to constant design and quality improvements, the product may look slightly
different from the picture.
SAFETY INFORMATION
Please read and understand this entire manual before attempting
to assemble, operate or install the product.
CAUTION
• If you solder the joints during installation of the faucet, the seats,
cartridges, and washers must be removed before using a flame
or the warranty will be voided on these parts.
• Cover the sink drain to avoid losing parts.
WARNING
• Protect your eyes with safety glasses when cutting or
soldering water supply lines.
•
When making water line connections, HAND TIGHTEN. DO
NOT OVERTIGHTEN. Do not use PTFE pipe tape, plumber’s
putty, pipe dope or any other type of sealing compound on
water inlet or threads. Additional compound is unnecessary.
A watertight seal between the thread inlet and supply tube is
achieved by compression.
PREPARATION
Before beginning assembly of product, make sure all parts are
present. Compare parts with package and hardware contents list. If
any part is missing or damaged, do not attempt to assemble the
product. Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench,
Slip Joint Pliers, Pipe Wrench, Phillips Screwdriver, Silicone and
Supply Lines.
Installation may vary depending on how the previous faucet was
installed. Supplies necessary for the installation of the faucet are
not all included; however, they are available wherever plumbing
supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines,
then turn on the old faucet to release built-up pressure. When
installing the new faucet, hand tighten the connector nuts.
DO
NOT OVERTIGHTEN.
Connections that are too tight will reduce
the integrity of the system.