Way2Call Hi-Phone Installation Guide
Page 6
Installation (Divers and Phone Software)
To install the Hi-Phone drivers follow this procedure:
1.
Make sure the Hi-Phone device is NOT connected to your
computer. Leave the USB connector disconnected for now.
2.
Insert the Way2Call CD. It will ask you if intend on using the
USB device. Answer YES. Plug the hi-phone USB cable into
your computer.
3.
At this point the system will automatically install the drivers.
Please wait for it to complete. It may install up to 3 drivers and
may take a few minutes. If it does not detect the device,
restart your system. It should detect it on startup and install
the drivers.
4.
Next, select "Install Hi-Phone software and drivers for
windows" from the CD installer.
5.
This will install the remaining drivers required by the unit. The
installer will scan your system and detect your device.
6.
When the install is complete, you will need to restart your
computer.
To install the HomeSeer Phone software:
1.
Start HomeSeer by double clicking on the HomeSeer 2 icon on
your desktop
2.
From the Edit menu select Setup, this displays the Setup web
page.
3.
Select the General tab
4.
Make sure that “Launch HomeSeer Phone at Startup” is set to
“YES”.
5.
Select the Phone tab.
6.
Under Line Specific Settings select “Way2Call Hi-Phone
Desktop”, and then click the “Create Line” button.
7.
Click “Save” at the bottom of the page to save your settings.
8.
You can select this line again from the drop-down menu to
adjust settings for the line, such as the number of rings to
answer, etc.
