Way2Call Hi-Phone Installation Guide
Page 4
Requirements
Before installing the Hi-Phone, make sure you have HomeSeer
version 2.0.0 or later installed. You can download the latest version
of HomeSeer HS2 from the download web page on our web site at
www.HomeSeer.com
.
Installation (Hi-Phone)
The Hi-Phone contains the following connections:
1.
RJ11 Female, marked "Line" for connection to your incoming
phone line
2.
RJ11 Female, marked "Phone", for connection to your in-house
telephones
The Hi-Phone should be installed where the telephone line enters the
home. This allows any phone in your home to control your computer.
The following diagram shows the connections.
1.
Connect your incoming phone line to the "Line" jack on the
rear of the Hi-Phone
2.
Connect the line going to all your in-house phones to the
"Phone" jack on the rear of the Hi-Phone
3.
Do not connect the USB connection to your computer at this
time
4.
After the hardware is wired, skip to the software installation
section to install the Hi-Phone device drivers.
Rear of Hi-
Phone device
Phone
Line
To telephones in the home
Phone line from telephone company
Hi-Phone
Wiring 1
