HomeTroller-SE Getting Started Guide – rev 3.0 10/12/2011
Page 14
Configuring Devices
Specifying Device Types
Before adding devices to the
HomeTroller, you must first
specify the types of devices that
will be used. The
Interfaces
Setup
screen is where you enable
and configure plug-in programs
that can be used with the
HomeTroller. Plug-ins are
designed to integrate the
HomeTroller-SE with other
hardware and software and to
add additional functionality to the
HomeTroller.
To get to this screen, launch the web interface (see page 10), click the
Setup
button beneath
the time and date bar, and then click the
Interfaces
tab.
Buttons appear under the columns for the type of hardware or software the particular plug-in
supports. By default, the button will be labeled
Disabled
, which indicates that the plug-in is not
enabled or not active. Click the button to enable the plug-in.
By default, this screen will be empty. Select the
Install More Interfaces
link at the bottom, or
click on the
Updater
button to get a list of available interfaces that you can add to the system.
Click the
SAVE
button to save the changes.
Z-Wave Devices
Refer to documentation included with your Z-Wave PC interface.
Interfaces Setup Screen
Figure 4: Interface Setup
