12
ADJUSTMENT SECTION
PROGRAM THE TRAVEL LIMITS AND FORCE SETTINGS
19
Travel limits regulate the points at which the door will stop when
moving UP or DOWN. The travel limit buttons are located under the
light cover (1).
NOTE: The opener will MOVE AUTOMATICALLY after setting the
DOWN limit at step 6. A complete UP DOWN cycle is performed in
order to “Set the Force” automatically. If the door is interrupted
during this process, the force will not be set and the process will
have to be repeated.
REFER TO THE DIAGRAMS:
TO PROGRAM THE TRAVEL LIMITS:
1.
Turn the Power ON and open the light cover. (The courtesy LEDs
will be on during this operation, and you may need to cover these in
order to see the program buttons clearly).
2.
Press the
“P”
button until LED 3 starts flashing and release.
3.
Press and hold the “+” button until the door moves to the desired
UP position. The “+” and “-” buttons can be used to move the door
UP and DOWN if required.
4.
Press the “P” button to set the UP limit. LED 2 starts flashing and
release.
5.
Press and hold the
“-”
button until the door moves to the desired
DOWN
position.
The “+” and “-” buttons can be used to move
the door UP and DOWN if required.
6.
Press and release the “P” button to set the DOWN limit. At this point
the opener will operate a complete cycle AUTOMATICALLY. This
will set the force of the motor, all LED indicators will be off after this
operation.
LIMITS AND FORCE ARE NOW SET.
Without a properly installed safety
reversal system, persons (particularly
small children) could be SERIOUSLY
INJURED or KILLED by a closing
door.remains ON.
•
Incorrect adjustment of garage door travel
limits will interfere with proper operation of
safety reversal system.
•
NEVER use force adjustments to compensate
for a binding or sticking garage door.
•
After ANY adjustments are made, the safety
reversal system MUST be tested. Door MUST
reverse on contact with 40 mm high object
laid flat on floor.
CAUTION
To prevent damage to vehicles, be sure fully open door
provides adequate clearance.
Connect Electric Power
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL INSTRUCTED
TO DO SO. Connect to properly fused and earthed power outlet.
-
Ensure all ropes and installation tools have been removed from the door.
-
When the opener is switched ON, the operator light flashes a number of times and then remains ON.
