HomeMatic HmIP-DLS, Инструкция по монтажу и руководство по эксплуатации

Страница: 40 / 51

40
Start-up
• Insert the key completely into the key clamp (s.
figure 6) .
• Retighten the screws so that the door lock sensor
fits securely on the key (s. figure 7) .
However, the screws should not be tightened too
much. The recommended tightening torque is
0.5 Nm.
• Insert the key together with the door lock sensor
into the key hole (s. figure 8) . Make sure that you
can read the “TOP” lettering.
When the neutral position of the lock cylinder is
horizontal, the “TOP” lettering will be horizontal
on the upper side of the door lock sensor
(s. fig-
ure 9) .
• Attach the desired cover (B) (white or silver) to the
door lock sensor (s. figure 10) .
• To ensure the correct detection of the end po-
sition of the lock cylinder, the door lock sensor
must first be fully unlocked in the lock (with the
lock latch) and then locked up to the stop.
The Homematic IP app will take you through all
other settings step-by-step for putting your door
lock sensor into operation.