33
8 Simple operator functions
After teach-in has been performed, simple operator
functions are available for use.
In the initial state, the three channels are taught-in on
the receiver as three on/off switches (ON/OFF). This
enables switching actuators to be switched ON/OFF.
In this respect, please note that directly taught-in
actuators switch as follows:
Switch/contact open – actuator ON
Switch/contact closed – actuator OFF
The shutter contact interface also enables two-way
switching to be performed.
A HomeMatic central control unit or
HomeMatic configuration tool can be used
to change the configuration of the shutter contact
interface. See also Section 7.3 for more information
on this.
9 Resetting to the initial state
Press and hold the teach-in button for at least 5 sec-
onds. The device LED starts to slowly flash red. If
you want to cancel the reset procedure at this point,
you can either press the teach-in button again briefly