Homematic IP HmIP-SWDM, Инструкция по монтажу и руководство пользователя

Страница: 48 / 56

48
Replacing batteries
To replace the batteries, please proceed as follows:
• Loosen the bracket (A) from the electronic unit
(B) by sliding it down and removing it to the back
(see figure 2) .
• Insert two new 1.5 V LR03/micro/batteries into
the battery compartment (F) , making sure that
you insert them the right way round (see figure 9).
• Pay attention to the flashing signals of the device
LED while inserting the batteries (see “7.4 Error
codes and flashing sequences” on page 50).
• Put the bracket back to the electronic unit.
Once the batteries have been inserted, the device will
perform a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED test display will
indicate that initialisation is complete by lighting up
orange and green.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
Never recharge standard batteries. Do not throw
the batteries into a fire! Do not expose batteries
to excessive heat. Do not short-circuit batteries.
Doing so will present a risk of explosion.