Homematic IP HmIP-SMI55-2, Инструкция по монтажу и руководство по эксплуатации

Страница: 44 / 53

44
Replacing batteries
To replace the batteries of the motion detector, please
proceed as follows:
• Once mounted, the electronic unit (B) of the
motion detector can easily be pulled out of the
frame
(A) and removed from the mounting plate
(G) . To remove the electronic unit from the frame,
take hold of the sides of the electronic unit and
pull it out
(see figure 6) . You do not need to open
the device.
• Turn the electronic unit over to remove the bat-
teries.
• Insert two new 1.5 V LR03/micro/batteries into
the battery compartment, making sure that you
insert them the right way round
(see figure 7) .
• Put the electronic unit back into the frame. Make
sure that “TOP” and the arrows on the back side
of the electronic unit point upwards and that the
clips on the mounting plate latch into the open-
ings on the electronic unit.
• Please pay attention to the flashing signals of the
device LED while inserting the battery (see „10.4 Er-
ror codes and flashing sequences“ on page 47).
Once the battery has been inserted, the motion detector
will perform a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED test display will indi-
cate that initialisation is complete by lighting up orange
and green.