Homelite Expand-it UT15702A, Руководство оператора

Страница: 7 / 12

7
n Align the bolt holes and push the long bolt (1/4-20
x 1-1/2 in.) through the handle side.
n
Place short bolt (1/4-20 x 1 in.) through opposite side
of clamp. Install flat washer, lock washers and hex nuts
to hold the assembly in place.
n
After assembly is complete, adjust the position of the
handle for best balance and comfort.
n Tighten first the long bolt and then the short bolt.
ATTACHING THE SHOULDER HARNESS
See Figure 5.
n
Connect the latch on the shoulder harness to the
hanger.
n
Adjust the strap to a comfortable position.
REPLACING THE TRI-ARC® BLADE
See Figures 6 - 7.
To Remove Blade
n
Align the slot in the flanged washer with the slot in the
gear head.
n
Place the gear head locking tool through the slot in the
flanged washer and gear head.
n
Remove the blade nut by turning it clockwise (left-
handed threads).
n
Remove the cupped washer and the blade
To Install Blade
n
Place flanged washer over the gear shaft with the
hollow side toward the brushcutter guard.
n
Center the blade on the flanged washer, making sure
the blade fits flat and the raised hub goes through the
hole in the blade.
n
Install the cupped washer with the raised center away
from the blade.
n
Place the blade nut onto the gear shaft.
n
Insert the head locking tool through the flanged washer
and gear head.
n
Install the blade nut by turning it counterclockwise (left-
handed threads).
n
Tighten the blade nut and torque to 120 in.lb. minimum
(finger tight plus 1/2 turn).
ASSEMBLY
SHOULDER
HARNESS
SHOULDER
HARNESS
HANGER
Fig. 5
Fig. 6
GEAR HEAD
LOCKING TOOL
Fig. 7
BLADE NUT
CUPPED
WASHER
SLOT
FLANGED
WASHER
OPERATION
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
To avoid burns from hot surfaces, never operate unit
with the bottom of the engine above waist level.
BLADE
GEAR SHAFT
BOLT
LOCK
WASHER
LOCK NUT