IMPORTANT - please do not remove
clamp and splash guard from
hopper. Both parts are factory
installed and installation ready.
a.
Lubricate the insideusrface of the
rubber splash guard with liquid soap
to engaging disposer to sink flange.
(See 4A)
b.
Press firmly around the splash guard
to ensure it is engaged with neck of
the disposer.
c.
Fit splash guard lip into sink
flange groove using a slight
rocking motion.
INSTALL
DISPOSER TO
SINK FLANGE
USER GUIDE WITH
BUILT IN AIR-SWITCH
d.
Line up discharge elbow of disposer with
trap under mounting assembly. Tighten
the clamp around the splash guard. The
disposer with now hang by ifself .
e.
If you need to turn the disposer make sure
the sink flange does not turn. It will break
the seal created when installed. Go back
to steps 3A and 3B. Use only P or S type
Traps.
a.
Select a location on the bench top for
the air switch to be positioned
(recommended position is near the sink).
Mark and cut a hole, 33mm or 1-5/16inch
in diameter, in the bench top.
b.
Remove the nut on the push button and
place the push button on desired position
near the sink or the disposer on the
kitchen bench. (See 5A)
c.
Place the push button on the desired
position and tighten the nut underneath
with hand (Do not use wrench
tightening the nut). (See 5B)
d.
Finally to connect the tube to the
disposer. Push the other end of the PVC
tube to the air switch outlet. To ended
underneath the disposer. (See 5C)
Warning:
The disposer will be turned on once
it connected. During installation,
please be sure that the disposer is
disconnected. (See Fig 4.1)
4D
®
5C
5A
5B
On/Off
4A
4B
Clamp
Sink Flange
Drain Housing
Splash Guard
4C
Fig 4.1
