a. KNOCK OUT PLUG
Using a blunt instrument (steel punch or
wooden dowel), knock out entire plug
(see 2A). Do not use a screwdriver or
sharp instrument. When knockout plug
falls into disposer, you may remove it and
put it in rubbish bin.
b. CONNECT HOSE
Connect the dishwasher hose using a hose
clamp. If the hose size is different, you will
need a stepped rubber adapter.
DISHWASHER CONNECTION
(IF NECESSARY)
CONNECT DISCHARGE ELBOW
a.
Connect the discharge elbow to
the disposer (See 3A), proceed to
step 4 and then connect bottom of
the elbow by tightening the slip nut.
b.
If you are connecting to a dishwasher,
return to section 2A. If not, make sure
all plumbing connections are tight
and in accordance with all plumbing
codes and ordinances. Run water
and check for leaks.
ATTACHING
THE DISCHARGE ELBOW
If you are connecting to a dishwasher, complete the following
step. If a dishwasher is not to be connected, go on to section 3.
*The disposer will not comply with the relevant
Australian Standard if the outlet is opened
2A
3A
d. Be sure your sink is clean. Pack the
underside rim of the sink flange with
plumber’s putty. Position the sink
flange so it is centered and
readable as you look into your sink.
Push the sink flange firmly into the
sink opening to make a good seal.
DO NOT move to rotate the sink
flange once seated or the seat may
be broken.
e. Make sure that the rubber gasket
seats below the sink flange properly.
From under the sink, while holding the
sink flange firmly with one hand, line
up the notches in the mount ring with
the protrusions on the sink flange.
Slide the ring assembly up onto the
sink flange, ‘past the protrusions and
give the mount assembly a 1/4 turn so
that it will hang by itself.
Tighten the 3 mounting screws evenly
with a screwdriver (see 1D). Do not
over tight the screws! Trim off excess
putty.
c. Next, seperate the sink flange with
the rubber gasket from the rings
asssembly (See 1B).
Keep these assembled parts together
and set aside. Before you connect the
disposer to the 3-bolt mount system
under the sink, you may want to
practice engaging the ridge on of the
splash guard to the groove on the
bottom of the sink flange (see 1B).
Rubber Gasket
Protector Ring
Mount Ring
Screws
Sink Flange
1C
1D
1B
