4
5
Installing the Camera
ATTENTION!
Prior to drilling and inserting the screws, make sure that there are no electric cable pipes,
etc. in the wall that may become damaged.
1.
Camera Lens
2.
12 pcs IR LED
3.
Antenna
4.
Power Jack
5.
Camera Stand
6.
1 EDS
7.
Microphone
8.
Channel Switch
9.
Power adaptor
Installing and Connecting the Devices
Select a suitable installation site from which you want to monitor the desired object. A suitable
installation site has the following features:
•
dry
•
as dust-free as possible
•
little vibrations
Select an installation site that is not screened off by reinforced concrete walls, mirrors, metal
shelves, etc. There should not be any appliances with strong electric fields close to the sender
and receiver. Any strong electric environment could cause the interference and reduce the
performance
Fastening the wall bracket
•
Look for a suitable place for mounting (with a socket
close-by)
•
Screw the wall bracket with the supplied screws to a
suitable wall or a suitable platform, use dowels if relevant.
Connecting the Camera
Connect the low voltage plug of the power unit to the voltage supply jack of the camera.
Pay attention to the correct input voltage of 7.5V DC!
•
Insert the plug-in power unit into a suitable mains socket.
•
The camera is now ready for use.
•
good air circulation
•
with a power outlet in close vicinity
Installing the Receiver
Install the monitor approx. 1 m above ground (better receiving condition). There must be a power
outlet in proximity to the receiving site.
ATTENTION!
Only place the monitor on rugged and stable surfaces. Sensitive surfaces or surfaces that
dissolve softeners may become damaged. Use a suitable underlay.
1.
Antenna
2.
Power LED
3.
Channel LED
4.
Channel SEL
5.
Power ON/OFF
Parts of the Remote Control
Remote Control Instruction
1. Press the CH1 button to view
the camera 1 image.
2. Press the CH2 button to view
the camera 2 image.
3. Press the Auto Scan button to
scan two cameras image.
4. Make sure you are within
Infrared valid distance (2m/ 6
feet) and 30 degree receiving
angle from receiver.
Notice:
1. Camera 1 is preset to CH1
2. Camera 2 is preset to CH2
6. DC Power
7. Video Output Jack
8. Audio Output Jack
9. A/V Cable
10. Power adaptor
Channel button
Scan button
Receiver
Camera 1
Camera 2