HoMedics THERA P BPW-050, Руководство пользователя

Страница: 18 / 38

34 33
P Po ow we err S So ou urrc ce e:: Two 1.5V DC (AAA) Alkaline batteries
M Me ea as su urre em me en ntt
M Me etth ho od d::
Oscillometric
M Me ea as su urre em me en ntt
R Ra an ng ge e::
Pressure: 40~250 millimeters Mercury
(mmHg)
Pulse: 40~199 beats/minute
A Ac cc cu urra ac cy y::
Pressure: ±3 mmHg
Pulse: ±5% of reading
P Prre es ss su urre e S Se en ns so orr:: Semi-conductor
IIn nfflla attiio on n::
Pump driven
D
De efflla attiio on n::
Automatic Pressure release valve
M Me em mo orry y C Ca ap pa ac ciitty y:: 30 memories for each User (60 total)
A Au utto o--s sh hu utt--o offff:: 1 minute after last button operation
O Op pe erra attiio on n
E En nv viirro on nm me en ntt::
Temperature: 50°F~104°F (10°C~40°C)
Humidity: 40%~85% RH max.
S Stto orra ag ge e
E En nv viirro on nm me en ntt::
Temperature: 14°F~140°F (-10°C~60°C)
Humidity: 10%~90% RH max.
W We eiig gh htt:: 0.25 lbs (without batteries)
W Wrriis stt
C
Ciirrc cu um mffe erre en nc ce e::
5.3"- 8.6" (13.5 - 22cm)
D Diim me en ns siio on ns s::
3.25"(L) x 2.75"(W) x 2.60"(H)
82mm(L) x 69mm(W) x 66mm(H)
Type BF
Device and cuff are designed to
provide special protection against
electrical shocks.
SPECIFICATIONS
Note: These specifications are subject to change
without notice.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not turn on
when the
START/STOP
button
is pushed.
Batteries have
run down. Replace them
with two new AAA
alkaline batteries.
Battery polarities have
been positioned
incorrectly. Re-insert the
batteries in the
correct positions.
EE measurement
error symbol shown
on display or the
blood pressure value
is displayed exces-
sively low
(or high). Cuff has been placed
incorrectly. Wrap the cuff properly
so that it is positioned
correctly.
Did you talk or move
during
measurement? Measure again.
Keep wrist steady
during measurement.
Shaking of the wrist
with the cuff on.
E1 error symbol
shown on display Air circuit
abnormality. Measure again.
E2 error symbol
shown on display Inflation pressure
exceeding 300 mmHg. Switch the unit off,
then measure again.
E3 error symbol
shown on display Data error. Remove and reload the
batteries.
“
--” appears on
display
Recalibration alert. Refer to page 28 for
more information.
TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page (See page 35).