HoMedics Thera P BPA-150, Руководство пользователя

Страница: 31 / 67

30
TROUBLESHOOTING
If any abnormality arises during use, please check the following points
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not turn on when
the START/STOP button is
pushed. Batteries have run down. Replace them with four new
AAA alkaline batteries.
Battery polarities have been
positioned incorrectly. Re-insert the batteries in the
correct positions.
Battery pack is not properly
installed.
Remove the battery pack
and follow loading
instructions on p. 11.
Power switch is in the “Off”
position.
Slide power switch into the
“On” position.
EE measurement error
symbol shown on display or
the blood pressure value is
displayed excessively low
(or high). Cuff has been placed
incorrectly. Wrap the cuff properly so
that it is positioned correctly.
Did you talk or move during
measurement? Measure again. Keep arm
steady during measurement.
Shaking of the arm with the
cuff on.
Er error symbol shown on
display - measurement
result exceeds measurement
range. Did you move during
measurement?
Shaking of the arm with the
cuff on. Measure again. Do not
move during measurement.
E1 error symbol shown on
display Air circuit abnormality. Cuff
tube may not be plugged
into monitor correctly. Check cuff connection.
Measure again.
E2 error symbol shown on
display Inflation pressure exceeding
300 mmHg. Switch the unit off, then
measure again.
E3 error symbol shown on
display Data error. Remove and reload the
batteries.