GB
memyelos.com
13
Step 5: Gently remove the applicator from the base.
Step 6: Press the cartridge activation button located on the upper part of the
applicator. The indicator light will turn white, and you will hear the fan inside the
applicator.
Step 7: Gently place the applicator on your skin, so that the two RF skin contact bars
are in complete contact with the skin.
Note: The applicator will not work unless both RF skin contact bars are touching the skin.
Step 8: After every flash, move the applicator to the next neighboring spot over the skin
by gliding in one continuous, slow motion. Avoid overlap between adjacent pulses.
Note: The applicator will automatically turn itself off if no pulses have been emitted for one
continuous minute. To turn the applicator back on, press the activation button located on the upper
part of the applicator.
DO NOT hold the applicator window still over one spot on the skin and flash multiple
light pulses on the skin. Doing so causes too much heat to build-up and may result in
skin swelling, blisters, or temporary or permanent changes in the colour of your skin.
After each flash, move the treatment window to a different skin spot.
Wait for at least 10 seconds before returning to a previously treated skin spot.
Step 9: Repeat Step 8 until you have covered the entire area 3 to 4 times. Depending
on the body part, the treatment time will vary.
Tips: When using the system on difficult to treat areas (e.g. underarm) apply the
applicator in 2 directions: left/right and up/down for full coverage. You can treat all
body areas during the same treatment session.
