26
TROUBLESHOOTING
If any abnormality arises during use, please check the following points
Note: If the unit still does not work, contact HoMedics Consumer Relations.
Under no circumstance should you disassemble or attempt to repair
the unit by yourself. Contact information for HoMedics Consumer
Relations Department can be found on the warranty page.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not turn
on when the
START/
STOP button is
pushed.
Batteries have
run down.
Replace them with
four new AAA LR03
alkaline batteries.
Battery polarities
have been positioned
incorrectly.
Re-insert the batteries in
the correct positions.
EE measurement error
symbol shown on dis-
play or the blood pres-
sure value is displayed
excessively low
(or high).
Cuff has been placed
incorrectly.
Wrap the cuff properly so
that it is positioned cor-
rectly. Measure again.
Did you talk or move
during measurement?
Keep arm steady during
measurement. Measure
again.
Shaking of the arm with
the cuff on.
E1 error symbol shown
on display
Air circuit abnormality.
Cuff tube may not be
plugged into monitor
correctly.
Check cuff connection.
Measure again.
E2 error symbol shown
on display
Inflation pressure
exceeding 300 mmHg.
Switch the unit off, then
measure again.
E3 error symbol shown
on display
Error determining
measurement data.
Measure again.
EP error symbol shown
on display
System error.
Measure again.
15-0144 BPA-730-CA_IM_v4--02.indd 26
2015/10/28 下午6:14