9
POSITIONING THE DISHWASHER
WATER CONNECTION
INSTALLATION
NOTE:
Hard water conditions will negatively affect the performance of your dishwasher. Hard water conditions will also
contribute to lime desposits (white film substance) and/or scaling on the stainless steel surface of the dishwasher and
heating element, located in the sump underneath the removable filter screen. To minimize this, operate/rinse the inside
of the dishwasher once a week while it is empty, using 1 cup of white vinegar.
WARNING!
FAILURE TO RELIEVE WATER PRESSURE BEFORE DISCONNECTING THE QUICK-CONNECT FROM THE FAUCET,
WILL RESULT IN BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE OF INCOMING WATER CAN BE VERY HOT, AND BACK-
PRESSURE OVER-SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING.
DANGER!
DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE SUPERVISION OF CHILDREN IS ALWAYS
IMPORTANT AROUND DISHWASHERS.
ATTENTION:
The content of this manual can be very helpful to the users. After installation, please make sure to keep
this manual.
1. Screw the faucet adapter onto or into the faucet tap. Check for leaks. If there are any leaks, use Teflon tape to seal
them. Faucet adapter has thread size of 55/64''–27 female or 15/16''–27 male threads, if the supplied faucet adapter is
not fitting with your faucet, please find another adapter in local hardware store.
2. Connect the hexagonal connector of the drain hose to the drain port on the back of the dishwasher.
Do not over tighten to avoid damage to its threads.
3. Connect the star-shaped connector of the inlet hose to the inlet port on the back of the dishwasher.
Do not over tighten to avoid damage to its threads.
4. Connect the circular connector of the drain hose onto the longer (bottom) male connection on the quick connect.
5. Connect the circular connector of the inlet hose onto the shorter (top) male connection on the quick connect.
6. Attach the quick connect onto the faucet adapter, by pulling down the outer locking collar on the quick connect,
while pushing the quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar. Check that the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose connections. If leaks are located,
immediately close the water supply and repair the hose connections.
IMPORTANT
1. Once the water supply line is opened, the inlet hose will be pressurized, even if the water supply line is immediately
closed.
2. To relieve water pressure from inside the inlet hose, make sure the water line faucet is closed. Then, press and hold the
red pressure relief button on the quick connect until water stops flowing.
How to Disconnect the Dishwasher
1. Shut off the water supply at the faucet.
2. Disconnect the power supply cord.
How to Start the Dishwasher
The following things should be checked before starting the dishwasher.
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. There is no leakage at the conductor connections.
4. The wires are tightly connected.
5. The power is switched on.
6. The inlet and drain hoses are knotted.
7. All packing materials and printings are taken out from the dishwasher.