18
•
Installing the Controller
3 5 ( / , 0 , 1 $ 5 < Y
Connecting the incoming telephone lines
This step is necessary only if you intend to
add a handset or phone jack to the network.
If you are adding only Data Jacks to the
network, you may skip this step.
Note: It is recommended that you record the
telephone number for each incoming line in
the same location where you recorded your
Controller serial number. This information will
be helpful should you want to restrict specific
devices on the network from accessing
certain lines.
For single-line telephone wiring
Use the following procedure if the telephone
wiring coming into your building consists of
single-line wires (that is, each cable carries
only one telephone line).
Procedure
1.
Connect one of the RJ-14 cables from
your Controller kit to your primary
incoming telephone line. Plug the other
end of the cable to the Line 1 Connector
on the Controller.
2.
Use the second RJ-14 cable to connect
your secondary incoming line to the Line
2 Connector.
See the following illustration.
Note: The green Line Status Indicator on
a connector will illuminate within 10
seconds after the line has been properly
connected.
