Remark:
A. After preset the cleaning time, the robot should be in standby status. Do
not turn off the robot manually, unless the preset cleaning time function will
be canceled. After presetting cleaning time, better to make the robot on the
auto charging base and make sure it is in charging status.
B. Please make sure the robot is with enough power, unless the robot will not
work on preset time when it is in short power.
II. Function Introduction of Virtual wall:
Virtual wall, an accessory of the cleaner, can block area by sending special
infrared signal so as to prevent the Cleaner from entering some unnecessary
areas.
Attention:
1. Open the battery bottom before using, check the right positive and negative
electrode and place 2x”D” batteries into the box correctly. Pay attention to the
electrode or the Virtual Wall will not work, resulting the damage and accident.
2. The battery consumption duration is related to the selected transmitting
distance and working duration, please select proper transmitting distance and
low transmitting power to save the battery, so don’t forget to turn off the
power switch while unused.
3. There will be some difference in the direction, transmitting infrared signal of
the Virtual Wall and receiving distance of the Cleaner due to environmental
impact and movement of the Cleaner during the actual using. The difference
above may vary based on the actual environment and different battery power
of the Cleaner and Virtual Wall.
III. Installation method of Virtual Wall:
1. The Virtual Wall is placed at the entrance to the stair or room generally.
2. You can place the Virtual Wall at proper position to stop the Cleaner
passing through some places.
3. Remove obstacles from the area you want to block in front of the Virtual
Wall as much as possible for fear of poor effect.
Attention:
1. The Virtual Wall should be placed at the same level of the ground where
the Cleaner is running.
2. You should check whether the Cleaner can pass the Virtual Wall while
using it first.
3. The distance between the Virtual Wall and recharger should be more than
3m, or there will be interference.
4. The Docking Station should not be installed within the signal scope of the
Virtual Wall.
9. Virtual Wall:
I. Using Method & Functional status of virtual wall
Overall Display
Function Instruction
1. Power switch
Press the power switch to
turn on/off the virtual wall.
Note: the virtual wall will
turn
off automatically after 2
hours.
If you need using it again,
please turn it on.
2. Signal head
3. Near-infrared transmitting
head
4. Power LED
1
2
3
4
10. Trouble-shooting
Cause
Solution
The robot don’t work
or cleaning effect ion is
poor
1. Whether the filter is clean or need to replace.
2. Make sure the mouth of the main brush is clean
and also clean the main brush.
3. Driving wheels are wrapped or not.
4. Clean the ground detection sensor.
Robot is not charged
successfully.
1. Check whether the adaptor is connected in right
way, and make sure the LED in the charging base
is on.
2. If the robot is in too short power, please
charging the robot manually.
3. Make sure there is no obstacles in front of the
charge base.
(28
(29
