14
Assembly - Installing the Light Kit
Attaching the light kit
Installing the Light bulbs
1
2
□
Remove one screw (N) from the black bracket below the
fan motor assembly (D). Loosen, but do not remove the
other two screws.
□
Connect the blue wire exiting the bottom of the fan motor
assembly (D) with the black wire from the top of the light
kit fitter assembly (E).
□
Connect the white wire exiting the bottom of the fan motor
assembly (D) with the white wire from the top of the light
kit fitter assembly (E).
□
Attach the light kit assembly (E) to the fan motor assembly
(D) by securing with the two screws loosened in first step.
Push the light kit assembly (E) up to engage the screw
heads in the screw slots and turn to secure. Tighten each
screw firmly.
□
With the power off, install the two fluorescent bulbs (I)
(Max. 13W, provided) into the light bulb sockets.
□
Place the glass bowl (H) into the light kit assembly (E),
aligning the three flat areas on the top flange of the glass
bowl (H) with the three raised dimples in the light kit
assembly. Turn the glass bowl (H) clockwise until it stops.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
CAUTION:
Over lamping the fan will result in the fan lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off the light and replacing the
bulbs with the correct wattage bulbs
WARNING
: Do not overtighten when installing the glass shade
into the light kit assembly. Allow the glass shade to cool
completely before removing.
E
N
D
G
E
H
I
