Seat
Temp
Water
Temp
3 Seconds
Nozzle
Cleaning
Nozzle
Cleaning
Seat/Water Temperature Control
Seat/Water temperature is adjustable. (4 levels)
(Off - Low - Middle - High)
To reduce the chance of low temperature burns,
the seat has a safety feature that turns to low
temperature (35 C, 95 F) when seat is occupied
for more than 15 minutes consecutively.
3 Seconds
Water
Temp
Stop
Stop
Pulse
Energy Saving Fuction
ECO 1
- This mode is activated by pressing the Energy
Saving button until the yellow LED lamp lights up.
(Seat and water temperature will be kept at 32 C)
ECO 2
- This mode is activated by pressing the Energy
Saving button until the green LED lamp lights up.
(Seat and water heater will be kept off until seated)
ECO OFF
- Press the Energy Saving button until LED lamp
turns off.
When the unit is occupied, it adjusts to the preset
temperature and it returns to the saving mode when
seat is unoccupied.
If the seat and water temperature are off, they will
remain off.
Nozzle Cleaning
When selecting Nozzle Cleaning while not seated,
the nozzle cleans itself 3 times. Then nozzle extends
and stops for manual cleaning process.
Clean the nozzle with a brush and press the STOP
button after completion of manual cleaning.
NOZZLE CLEANING will not operate if the seat sensor
is activated.
Night Light
Blue LED night light provides enough brightness to
see the toilet without turning on the bathroom light.
Night light can be turned on and off by pressing
‘+’ for 3 seconds while not seated.
Night light setting cannot be adjusted if seat
sensor bypass feature is activated.
Automatic tank draining
To protect from water contamination, the water tank
will be drained(replaced) for 2 minutes if the seat is
not used for 48 consecutive hours.
This feature is deactivated from the factory.
To activate this feature, press Stop and Water Temp.
buttons for 3 seconds.
Sitz Bath
Wash or Bidet is switched to Wash Sitz Bath or
Bidet Sitz Bath if Nozzle Cleaning button is pressed
during use.
Water pressure is switched to 1st level regardless
of preset water pressure settings and Sitz Bath
operates for 5 minutes.
LED of Nozzle Cleaning turns on during the
operation of Sitz Bath.
Select the Nozzle Cleaning again to switch to
normal Wash or Bidet.
Seat Sensor Bypass
The seat sensor can be activated and deactivated by
pressing Pulse button for 3 seconds.
If the seat sensor is deactivated, the unit works
without occupying the seat and select features*
cannot be controlled.
Night light, Silent mode, Nozzle cleaning.
* Features
Reset
Press and hold the Stop button for 5 seconds.
After 3 seconds, the seat will power off.
Keep holding another 2 seconds and the seat will
power back on. This completes the factory reset
process.
Operation
3 Seconds
3 Seconds
