AC-DC-1137
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
HEX WRENCH-1
1
HEX WRENCH-2
1
Step 1:
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or are unsure how to proceed with the assembly, call our
Customer Service Center at 1-800-206-8095.
Do not attempt to assemble table if any parts are missing
or damaged
.
Step 2:
Align
the
holes
in the
“
U
”
bar
,
located
underneath the seat frame(A),with the
holes
in
the
metal
spring
plates
of
the spring rail(C).Attach
the seat
frame(A)using
the
screws(E),metal
plates(G)spring washers(F)and
nuts(H)
as
indicated in Figure
2.
Once
all
four
have been inserted, tighten each screw and nut using the hex wrench-1 (Q) and
hex wrench-2 (R).
Do not to over tighten the any of
the screws
.
Over tightening may strio bolts or damage
the
welds
or
frame
.
QTY
SPRING WASHER
E
8.5 X 2.0 MM
5/16"NUT
METAL PLATE
PARTS LIST
DESCRIPTION
A
B
C
D
E
F
5/16" X40 MM
BOLT
G
H
I
J
K
2
Figure 1.
BACK CUSHION
SEAT CUSHION
SEAT FRAME
BASE &ARM
ASSEMBLY
Figure 2.
2
2
2
PILLOW
8
8
8
8
Step 3:
Place the seat cushion (I
)back cushion(J),and pillow(K) on each chair as indicated in
Figure2.
Secure
the seat cushions
to the chair frames using the attached straps with hook&loop fasteners
.
Then your chair should be ready for use
.
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Page 4
1
"U" BAR
ROCKER
ASSEMBLY
FRONT
C
E
D
F
E
