6
Assembly
1
ATTACHING THE BACK CROSS BAR AND THE U SUPPORT BAR TO THE RIGHT AND LEFT
ARMS
□
Loosely attach the Back Cross Bar (D) to the inside back of the
Right and Left Arms (A&B) with Bolts (AA) through Lock
Washers (GG) and Metal Washers (EE).
□
Loosely attach the U Support Bar (E) to the Right and Left Arms
(A&B) with Bolts (BB) through the Lock Washers (HH) and Flat
Washers (FF).
□
Once all the bolts are in place, securely tighten Bolts (AA) with
the Hex Screw Driver ( JJ ) and tighten Bolts (BB) with the Hex
Wrench (KK). See figure.
NOTE
: Do not tighten bolts completely until assembly is
completed.
2
ATTACHING THE CHAIR SEAT TO THE CHAIR BASE
□
Place the Chair Seat (C) on a non-abrasive flat surface. Align the holes on the support bar on the underside of the chair seat with the holes
on the Spring Plates which are pre-attached to the chair base. Insert Bolts (CC) through the Flat Washers (FF), C Clamp Plate (II), Support
Bar attached to the underside of the seat, and Spring Plates attached to the U Support Bar (E) as shown in the diagram.
□
Secure the bolts with Flat Washers (FF), Lock Washers (HH), and Nuts (DD). The support bar and spring plate should be sandwiched in
between the C Clamp Plates (II). See figure.
□
Once all the Nuts (DD) and Bolts (CC) are in place, securely tighten all the Bolts (CC) and Nuts (DD) with the Hex Wrench (KK).
WARNING:
Improper assembly may result in serious personal
injury.
NOTE
: Do not tighten bolts completely until assembly is
completed.
B
E
EE
GG
AA
D
FF BB
H
C C
FF
FF
H
H
H
DD
I I
C
B
E
D A
