CALIFORNIA PROPOSITION 65
Combustion by-products produced when using this
product contain carbon monoxide, a chemical known to
the State of California to cause birth defects (or other
reproductive harm), and other chemicals known to cause
cancer.
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
2. Turn gas control knob the “ON/MIN”.
3. Push in gas control knob all the way
4. If the burner does not light in 15
1. Push in gas control knob slightly and turn to “OFF”.
TO TURN OFF GAS
INSTRUCTIONS D'ALLUMAGE
POUR ÉTEINDRE L'ALIMENTATION EN GAZ
1. Enfoncer légèrement la poignée de la soupape de gaz et
2. Tourner la poignée de la soupape de gaz en position MARCHE/MIN.
3. Enfoncer complètement la poignée de la soupape de gaz et la
4. Si le brûleur ne s'allume pas en 15 secondes, relâcher la poignée et
5 minutes avant d'essayer d'allumer
le brûleur à nouveau. Répéter les étapes 1 à 3.
1. Enfoncer légèrement la poignée de la soupape de gaz et la tourner
turn to “OFF”.
and hold. ontinue to press the
ignition button for 15 seconds.
seconds, release the knob and it will
pop back out. Wait 5 minutes before attempting
to light the burner again, repeat step 1 to 3.
la tourner en position ARRÊT.
maintenir en place.Continuer d'appuyer sur le bouton d'allumage
pendant 15 secondes.
elle ressortira. Attendre encore
en position ARRÊT.
OFF (Arret)
M A X
( M A X )
1 AAA
1.5V
IGNITOR
Disposotof d’allumage
ON/MIN
(MARCHE/MIN)
Good
Bad
Yellow
Yellow
Light Blue
Light Blue
Blue
Blue
4
1
1
Battery Installation
2
Lighting Instruction
□
Make sure the control knob is in the “OFF” position.
□
Unscrew the push button cap on the igniter module located on
the control panel to access the battery compartment.
□
The igniter module requires one AAA size battery.
WARNING:
1. Please observe proper polarity and use the correct
battery type when placing or replacing the battery.
Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is
to be left unused for a long period of time.
□
Push in gas control knob slightly and turn to “OFF”.
□
Turn gas control knob the “ON/MIN”.
□
Push in gas control knob all the way and hold. Continue to press
the ignition button for 15 seconds.
□
If the burner does not light in 15 seconds, release the knob and
it will pop back out. Wait 5 minutes before attempting to light
the burner again, repeat above process.
□
Observe Flame Height When Lit. The burner will display blue and
yellow flames. These flames should be a blue / yellow color
between 1~2 in. height . These flames should not be yellow or
produce thick smoke. This would indicate an obstruction of
airflow through the burners. The flames should be blue with
straight yellow tops. If excessive yellow flames are detected, turn
off the burner and consult “Troubleshooting” on Page 15.
WARNING:
1. For your safety, read and follow the Lighting
Instructions in this manual and in the Rating Plate on
the appliance.
IMPROPER LIGHTING PROCEDURES COULD RESULT
IN A FIRE HAZARD OR EXPLOSION HAZARD OR
PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
Operation – Battery lnstallation and lighting the Fire Pit