NOTE:
The unit has a memory function with last settings
for heating level and flame brightness effect, unless the main
power to the unit has been interrupted.
NOTE:
Hold the Mode button for 3 seconds. This allows
the temperature unit to change from °C to °F or °F to °C. The
unit default is °F. This function is only available if using the
control panel.
NOTE:
When you plug in the unit each time, the fan runs
for 5 seconds followed by the heater.
15
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operation
OPERATION (CONTINUED)
1
3
Powering the Fireplace
Adjusting the Heater
2
Mode Button
Setting the Timer
4
Press the Mode button to cycle through the different
functions. Each time the Mode button is pressed, the
mode will enter the next function - Temperature, Timer,
Logset Brightness, Flame Brightness or Flame Color.
Push the Power button again to turn off all functions.
Push the Power button to supply power to all functions of
the fireplace and put the insert in a standby mode.
When the unit is in ON mode, the power icon indicator light
is green.
When the unit is in OFF mode, the power icon indicator
light is red. When the power is OFF, the unit stops working.
If the heater was operating before the power was turned
OFF, the fan will continue to run for 20 seconds to ensure
there is no heat trapped inside the unit.
The temperature mode controls the heater’s thermostat
setting.
Pressing the Up or Down “ ” buttons to select the
desired temperature.
The thermostat setting range is 59°F (15°C) to 86°F (30°C),
ON & OF (OFF).
When the ambient temperature is higher than the set
temperature, heater will turn off automatically.
The timer setting shoud be used to set the countdown for
the unit’s main power.
Push the Mode button to enter timer mode.
Press the Up or Down “ ” buttons to adjust the
timer setting from 0 hour (OFF) to 9 hours with 0.5 hour
interval.