7
Please call 1-800-283-7048 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for standard mounting
□
Loosen, but do not remove, the setscrews (LL) on the collar
on top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (E).
□
Carefully insert the hanger pin (BB) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (BB) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the setscrews (LL) on the collar on top of the fan-
motor assembly (E).
□
Remove the canopy bottom cover (JJ) from the canopy
(C) by turning the bottom cover counterclockwise until it
unlocks.
□
Loosen the two canopy screws (HH) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A)
from the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
3
1
WARNING:
Failure to properly install the locking
pin (CC) could result in the fan becoming loose and
possibly falling.
C
A
HH
JJ
C
D
E
JJ
B
CC
BB
LL
C
D
E
JJ
B
