16
17
Installing the tip restraint hardware
WARNING:
Installing the Tipping Restraint Hardware will
help prevent accidents or damage to the unit.
NOTE:
Installation of the Tipping Restraint Hardware (NN)
will provide a small space between the wall and the unit. This
will allow you to run power cords and connector cables to your
television or other devices placed on top of the Unit.
Assembly (continued)
When the Tipping Restraint Hardware (NN) is properly
installed, it can provide protection against unexpected
tipping of the Unit due to small tremors, bumps or
climbing.
Each Tipping Restraint Hardware (NN) includes one Unit
Anchor, one Wall Anchor, one Anchor Tether, and four
Anchor Screws. Use these to complete the following steps
for a proper installation.
Locate a secure wall stud behind the unit closest to the
left side.
Align the Unit Anchor with a wall stud and attach to the
Unit with two Anchor Screws using a Philips Screwdriver.
The Anchor Screws must pass through the Top Assembly
for proper installation.
Align the Wall Anchor in the center of the wall stud, at
level with the Unit Anchor, and attach with two Anchor
Screws using a Philips Screwdriver.
On the Anchor Tether, detach the cable from the connector
and loop the loose cable through the eyelets on the Wall
Anchor and Unit Anchor. Reattach the loose cable to the
connector, but do not tighten.
Locate a secure wall stud behind the unit closest to the
right side and repeat the steps above.
Tighten both Anchor Tethers by pulling the cable through
the connector.
Wall
NN
