Page 8
TROUBLESHOOTING:
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period
of three (3) years from date of purchase. This warranty applies only to the original consumer purchaser and only to
products used in normal use and service. If this product is found to be defective, the manufacturer’s only
obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion,
provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations,
neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly
installed, set-up, or used in any way not in accordance with the instructions supplied with the product. This
warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration,
or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not
apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal
wear and tear.
The manufacturer does not warrant and specially disclaims any warranty, whether express or
implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer
specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor / expense costs involved in the replacement or repair of said product.
SYMPTOM
Possible Cause
Solution
In motion sensing mode,
the light does not turn
on when there is motion
Wall switch or circuit breaker is off
Turn on a switch or circuit breaker.
Light bulb may be dead.
Test the light bulb in a known working
light fixture
Light bulb is loose.
Tighten the light bulb in the socket.
Incorrect or loose wire connections.
Check wire connections.
Too much sunlight is shining into photocell
sensor in the early evening.
Relocate fixture away from a western
facing wall.
Too much light is shining onto photocell
sensor due to another light source, such as a
street lamp or other light fixture.
Eliminate or turn off other light source,
block other light source from shining
onto photocell sensor, or relocate
fixture.
In motion sensing mode,
the light stays on
continuously.
False triggering caused by a heat source,
such as a heater or dryer vent, or heated
swimming pool.
Eliminate heat source or relocate fixture
The light comes on for
no apparent reason
Street or sidewalk traffic is triggering
motion sensor
Lower the sensitivity.
False triggering caused by a heat source,
such as a heater or dryer vent, or heated
swimming pool.
Eliminate heat source or relocate fixture
The light comes on
during the daytime or
too early in the evening
The fixture may be installed in a shaded
area, such as under a porch or eave,
preventing daylight from shining onto the
photocell sensor.
Relocate the fixture
