Technical Information
Homebase MK9 2NW
Model no.
PTG018S
Total Heat Output:
4.5 kW
Gas Consumption: 327 g/h
Gas Category:
I
3+(28-30/37)
Type of Gas:
Propane
Gas Pressure:
37 mbar
Injector Size:
1.05 mm
Pin Number:
359/BQ/568
Serial Number
Data Code
Countries For Use
GB and IE
The specifications and external appearance of this unit are subjected to change
without notice.
NOT FOR DOMESTIC USE
Warning: Accessable parts may be very hot. Keep young children away.
Read the instruction literature before using this appliance. The appliance must
installed in accordance with the instructions and local regulations.
Close the valve of the gas cylinder or the regulator after use.
For use outdoors and in well ventilated areas.
The use of the appliance in enclosed areas can be dangerous and is prohibited.
This appliance requires installation by a competent person
The appliance shall not be used in basement or below ground level
Only for use in well ventilated areas, with a minimum of 25% of the surface area
open.
The surface area is the sum of the walls surface.
fig. 11
HIGH
LOW
OFF
ON
Control Knob
Assembly Instructions
Assembly Instructions
Specifications
Stage 5 –
Operation
Igniting the Heater automatically:
1. Turn the Control Knob clockwise to "OFF" position.
See fig. 11.
2. Turn the gas supply "ON" at the cylinder regulator.
3. Push in the Control Knob on the Heater whist turning anti-clockwise to the "Ignition"
position (a clicking sound is heard), this will light the burner. If the burner does not
light, repeat this process.
See fig. 11.
4. When the burner is lit, keep the Control Knob pressed in for 15 seconds and then
release it.
5. If the burner does not stay alight, repeat steps 3 and 4. Adjust the heat by turning
the Knob anti-clockwise to the High/Low position.
6. To turn the heater 'OFF' turn the appliance clockwise to the 'OFF' position. Then
turn the cylinder valve or regulator switch to the 'OFF' position.
CAUTION:
-
If burner fails to ignite, turn the control knob and the gas bottle valve to the
off position. Wait five minutes before attempting to re-light the unit.
NOTE:
- The other burners will automatically cross light from the left to the right side
once the initial burner is ignited.
